A near-field wideband communication system is investigated in which a base station (BS) employs an extra-large scale antenna array (ELAA) to serve multiple users in its near-field region. To facilitate near-field multi-user beamforming and mitigate the spatial wideband effect, the BS employs a hybrid beamforming architecture based on true-time delayers (TTDs). In addition to the conventional fully-connected TTD-based hybrid beamforming architecture, a new sub-connected architecture is proposed to improve energy efficiency and reduce hardware requirements. Two wideband beamforming optimization approaches are proposed to maximize spectral efficiency for both architectures. 1) Fully-digital approximation (FDA) approach: In this method, the TTD-based hybrid beamformer is optimized by the block-coordinate descent and penalty method to approximate the optimal digital beamformer. This approach ensures convergence to the stationary point of the spectral efficiency maximization problem. 2) Heuristic two-stage (HTS) approach: In this approach, the analog and digital beamformers are designed in two stages. In particular, two low-complexity methods are proposed to design the high-dimensional analog beamformers based on approximate and exact line-of-sight channels, respectively. Subsequently, the low-dimensional digital beamformer is optimized based on the low-dimensional equivalent channels, resulting in reduced computational complexity and channel estimation complexity. Our numerical results show that 1) the proposed approach effectively eliminates the spatial wideband effect, and 2) the proposed sub-connected architecture is more energy efficient and has fewer hardware constraints on the TTD and system bandwidth compared to the fully-connected architecture.

翻译：本文研究了一种近场宽带通信系统，其中基站（BS）采用超大规模天线阵列（ELAA）为其近场区域内的多个用户提供服务。为促进近场多用户波束成形并缓解空间宽带效应，基站采用了一种基于真实时延器（TTD）的混合波束成形架构。除了传统的全连接式基于TTD的混合波束成形架构外，本文提出了一种新的子连接架构，以提高能效并降低硬件需求。针对两种架构，提出了两种宽带波束成形优化方法以最大化频谱效率。1）全数字逼近（FDA）方法：该方法通过块坐标下降法和惩罚函数法优化基于TTD的混合波束成形器，以逼近最优数字波束成形器。此方法确保收敛到频谱效率最大化问题的稳定点。2）启发式两阶段（HTS）方法：该方法分两阶段设计模拟和数字波束成形器。具体而言，分别提出了两种基于近似和精确视距信道的低复杂度方法来设计高维模拟波束成形器。随后，基于低维等效信道优化低维数字波束成形器，从而降低了计算复杂度和信道估计复杂度。数值结果表明：1）所提方法能有效消除空间宽带效应；2）与全连接架构相比，所提子连接架构能效更高，并且对TTD和系统带宽的硬件限制更少。